Rockville Auto Repair

You expect your heater/air conditioner to work like it should.  You have a control for temperature and one for fan speed.  You even have a control for what vents the air comes out of.  Don't be surprised one day if your blower fan develops a mind of its own and starts going crazy.  Most of the time, you may find that it starts blowing at full speed, and nothing you do to try to control it does any good.  This is what may be happening. Your blower motor has an electronic component called a resistor.  It does what its name says; it offers resistance.  When you want the fan to run more slowly, you turn the fan speed down.  That resistor accomplishes that by turning its resistance up.  When the resistor fails, the power has nothing to slow it and the fan speeds up.  It's a small part and can fail due to age or corrosion.  It's usually not an expensive part, either, but it's often found in a location that's not that easy for the technic ... read more

When it comes to your vehicle, driving it too much can cause some issues.  But what about not driving a vehicle enough? That has consequences as well. Here are a few things that can happen if a vehicle isn't driven enough.  When the engine doesn't operate, the oil isn't lubricating. That means some mechanisms that need periodic lubrication aren't getting it.  And oil that sits around breaks down over time.  In fact, some experts say you should change oil more often if your vehicle sits in the driveway than if you drive it regularly.  You've heard that expression, "Take it on the highway and blow out the engine.” Well, carbon buildup used to be a problem in older vehicles.  But the real culprit these days is moisture that builds up from combustion if your vehicle never gets hot enough to burn it off. That water vapor can mix with oil and cause sludge to form. There are many vehicle systems (battery, exhaust system, engine seals, etc.) that benefit fro ... read more

You know how heavy your engine and transmission are, so you can imagine how tough the parts that hold them onto your vehicle's sub-frame must be.  Not only must they support the weight, they also have to isolate vibrations and noise from the passenger cabin.  Pretty tall order, wouldn't you say? The parts that face that task daily are called the motor mounts, or engine mounts.  They are usually made of rubber with steel brackets.  Others contain a liquid for vibration and sound isolation.  Most vehicles have three or four motor mounts, and while rubber or hydraulic liquids do a good job of damping the vibrations from the engine, they also have their limitations.  The problem with rubber is that it gets old and brittle.  Plus, if there's an oil leak anywhere in your engine and oil gets on the rubber motor mounts, rubber will deteriorate even more quickly.  As for the liquid motor mounts, they can develop leaks and stop working.  Here are sign ... read more

Ever wonder what one of the best things is to ever happen to your vehicle's engine?  It's the little thing that usually looks like a can, the oil filter. Just like your kitchen sink strainer filters out errant particles of food from clogging your drain, the oil filter cleans out small particles that could cause your engine harm. Your engine operates in a dirty, hot environment and gathers a lot of tiny contaminants like dirt, dust, little metal shards and unlucky bugs that get sucked in.  Get those things circulating in your engine and those little particles can cause friction, which starts wearing out those finely machined metal parts.  You know how important it is to change your oil regularly.  It's vital that you change your oil filter at the same time to keep the oil as close to brand new as possible. Most oil filters look like a metal can with some holes in the bottom.  Inside there are carefully chosen materials that can screen out the contaminants while ... read more

Your vehicle may be like that famous battery bunny, the one that just keeps going and going.  But while it may seem sometimes like you never need to take your vehicle in to be worked on, there are some things you should keep your eyes, ears and nose out for. They are warning you about something that needs attention at your vehicle service facility. If a warning light is on, don't ignore it; do something about it.  There are warning lights for battery, oil, engine heat, tire pressure… you name it.  And the manufacturer put them there for a reason.  They're telling you something isn't normal. So when one goes on, have it checked out soon, especially the blinking Check Engine light.  The earlier you have any warning light issue diagnosed, the more likely you are to avoid a more serious problem. If your vehicle is vibrating or shaking, it's not only annoying, it could signal trouble.  You can bet your vehicle didn't do that when it came out of the fact ... read more

When the leaves fall, you might take a sightseeing trip to see them at peak color.  Or you may simply live in a spot where there are a lot of trees.  When those leaves get wet, you'd be surprised to learn just how slippery they can be.  We all know ice is slippery to drive on.  What causes tires to slip on ice is a thin layer of water that comes between the road and your tires.  Wet leaves can have the same effect.  The surfaces of leaves are super slick when they're dry, even worse when you add a little moisture.  There's one other thing about leaves.  They are smaller than each tire's footprint, so your tread grips the pavement with uneven traction. One study showed that your stopping distance can more than double on a surface covered with wet leaves when compared to that same road when it's dry.  Double! That can spell trouble.  So if you find yourself heading into an area with wet leaves on the road, slow down before you get into a ... read more

If someone asked you what gas made up the largest portion of the atmosphere, what would you guess? Well, it's not oxygen; it only makes up 20.9 percent.  But since we're talking about oxygen, you should know that your vehicle uses oxygen sensors to make sure your engine is running the way it should. The oxygen sensors measure how much oxygen is in your exhaust.  If there's too much, it means there's a problem with the mixture of fuel and air.  The sensor sends signals to computers in your engine and adjusts the mixture so it maximizes performance and efficiency.  It does this constantly.  Many vehicles have multiple oxygen sensors.  Some have one close to the engine, another close to the muffler.  Two measurements are better than one since they allow readings to be more accurate.  You may have a vehicle with a dual exhaust, so you'd have twice as many oxygen sensors. Your oxygen sensors can fail.  One thing that can damage them is contaminat ... read more

If your vehicle makes a grinding sound when you turn the steering wheel, it's speaking to you.  No, really, it is.  So listen to what it's saying and you could avoid a much more costly repair down the road. A grinding sound coming from the front of your vehicle when you are turning can offer some very informative clues as to what's going on.  One cause could be that there's a problem with the mechanical linkage that enables you to turn the wheels.  Another is that the hydraulic system that makes turning the steering wheel easier may have its own problems.  Think of it.  Hydraulic power steering has many components that need to work in tandem.  The power steering fluid may be too old and contaminated.  Or its level may be low. That may be caused by a leak somewhere in the system. A technician can check things over to find out exactly what's happening. Other causes of grinding while turning can be problems with the suspension in the front.  Yo ... read more

So you thought you only had two brake lights.  Look again and you'll see one in the center at a higher level than the two on either side of the vehicle.  They're sometimes in the inside of the vehicle behind the back window, or they could be in the deck lid, on the roof or on the spare wheel carrier, But why is that third brake on your vehicle? Experts say it helps prevent rear end collisions. Tests done by installing the third brake light in taxis and fleet vehicles showed fewer rear end crashes in the ones that had the extra light. The third brake light was mandated in new passenger cars in 1986 in the US and Canada.  The requirement was added to new light trucks and vans in 1994. Sometimes it's difficult to know if your third brake light is even working.  Many vehicles have bulb warning systems that alert you to non-functional bulbs, but not all do. Your vehicle service facility will often check to see if all your turn signals, taillights and headlights are worki ... read more

It's chilly outside. You flip on that switch that looks like a picture of a seat with little heat waves rising from it.  You expect soon you'll feel that warmth but… wait! It's not getting warmer.  Oh no, what's wrong with my seat heater? There could be lots of reasons it's not working, and it could be as simple as a fuse or as major as the heating element itself.  But it's something to leave to a pro to diagnose and repair. Let's say it turns out to be a blown fuse.  Simply replacing the fuse may not fix it because there was a reason the fuse blew in the first place.  It's possible the on-off switch has worn out or corroded.  Perhaps the wiring connection isn't completing the circuit (could be corroded or full of dirt) or the voltage reaching the heating element isn't correct.  There's a little sensor that keeps track of the seat heater's temperature called the thermistor.  When the seat is hot enough, it will stop the juice from heating ... read more